[Lolly]

Sheila, I just answered Anne's question about power ports on the Tykerb board, so hope you don't mind as I just copied and pasted it here, but all the info I have is contained. It wasn't particularly painful after wards as far as the old port site, I had the new one placed on the opposite side. But, in the past when the old port was replaced(I was on my third port) it was simply put in the old site after the old one was removed, and again, nothing particularly painful, just needed some hydrocodone for a couple of days, then regular Tylenol did the trick for a few more days, then it was fine except for sleeping on that side.

Bard Power Port
http://www.crbard.com/news/innovatio...lantedPort.cfm

I had my old port replaced recently with this type of port specifically so I could receive the CT injections and other "high speed contrast" injections, as I have lymphedema in both arms and needle sticks are a real danger for me as they aggravate the lymphedema. Your surgeon will have to confer with the CT/MRI department to insure that their imaging programs will accomadate the slight difference in the speed at which the dye circulates through the system, as the software is set to a precise timing related to the injection.

The procedure for placing the power port is the same as the one you underwent for the port you now have, hopefully there would not be any complications. Mine is placed on my left upper chest, just above the bra line. I had no problem with my procedure, and the port is comfortable although still somewhat tender to sleep on that side(it's been one month since the surgery).

I haven't had a scan yet which would necessitate using the port, but my nurses at my infusion room have told me to just come there (lucky for me located just across the way from the imaging department),and they will access the port for the scan techs, leaving the cathetar line in place for the techs to plug their line into, then I will go back to the nurses after and they will withdraw the line. That way no problems with inept techs damaging the port as it does take special training to do an access.

The reason they don't use regular ports for these type of high speed injections is the contrast goes in at a much faster rate than the slow IV drips, and it could possibly "blow" the catheter line from the port resevoir. Not a good thing. The power ports are designed to withstand the high speed injections. They are of course fine for the usual IV's and draws.
Hope this helps.

<3 Lolly<!-- / message --><!-- sig -->